Microwaves · parts
GE JNM3163RJSS microwave charcoal filter: JX81D fit check
GE's US Owner Center identifies the complete model JNM3163RJSS as an over-the-range microwave with recirculating venting and lists Microwave Filter Kit JX81D. GE's current parts detail for JX81D identifies WB02X35607 as the current charcoal-filter part. The linked 2015 family manual also lists JX81D as the recirculating kit, but its charcoal-filter section prints WB02X10943. No inspected GE source explicitly maps WB02X10943 to WB02X35607, so this page gives the current exact-model catalog path while warning owners to confirm if their existing filter or paperwork carries the older number.
Safety boundary
- Before replacing the charcoal filter, disconnect power at the breaker or unplug the microwave as the GE manual directs.
- Follow only the manual's filter-and-grille procedure. Do not remove the outer appliance cover or go beyond the filter cavity.
- The GE manual says microwave repair and adjustment are for properly qualified service personnel; leave internal, electrical, and high-voltage faults to a qualified servicer.
- If the grille, screws, filter grooves, or tabs are damaged or the documented fit does not match, stop and contact GE rather than forcing the filter.
Compatibility requires a direct model listing, explicit supersession, or equivalent manufacturer evidence.
Required identifiers
- Complete appliance model marking: JNM3163RJSS, including all suffix characters
- Serial number if GE parts lookup or support requests a production-range check
- Venting configuration: this page applies to the recirculating charcoal-filter path, not a model configured to vent outdoors
- Any part number printed on the removed charcoal filter or saved manual
Compatibility rules
- GE's exact-model Owner Center page identifies JNM3163RJSS as an over-the-range microwave with recirculating venting and lists Microwave Filter Kit JX81D.
- GE's Owner Center-linked JNM3163-family manual lists JX81D as the optional recirculating charcoal filter kit on printed page 8.
- GE's current parts detail for kit identifier JX81D identifies WB02X35607 as its current charcoal-filter part. This connects the exact-model JX81D listing to the current GE parts detail; it is not a claim that every JNM3163 suffix or another GE model uses this kit.
- The family manual's printed page 18 separately prints charcoal filter part WB02X10943. No inspected current GE source explicitly maps WB02X10943 to WB02X35607; preserve that mismatch and verify with GE if the existing filter or owner's paperwork shows WB02X10943.
- A charcoal filter is relevant when the microwave's vent air returns to the room. Check the actual installation and the exact model instructions before ordering; do not add a charcoal filter to an externally vented configuration solely because another model uses one.
Never assume
- Do not claim WB02X10943 is superseded by, interchangeable with, or dimensionally equivalent to WB02X35607; the retrieved GE sources do not explicitly establish that mapping.
- Do not extend the JX81D / WB02X35607 claim to another JNM3163 suffix or another GE microwave based on family resemblance.
- Do not treat the two listed part numbers as a proven conflict-free compatibility chain: the exact-model kit is JX81D, its current GE parts detail is WB02X35607, and the older manual independently prints WB02X10943.
- Do not infer that a charcoal filter is required when the unit is vented to the outside.
- Do not open the outer microwave cabinet or attempt internal electrical/high-voltage service.
Current exact-model fitment evidence
- Appliance identity: GE JNM3163RJSS, US Owner Center page; GE describes it as an over-the-range microwave with recirculating venting and dates manufacture January 2016–present.
- Current exact-model accessory entry: Microwave Filter Kit JX81D.
- Current GE parts detail: kit JX81D is identified as charcoal-filter part WB02X35607.
- The exact JNM3163 family manual identifies JX81D as the optional recirculating charcoal kit on printed page 8.
- The same family manual prints charcoal filter part WB02X10943 on printed page 18. The current source set does not document a direct supersession from WB02X10943 to WB02X35607; confirm with GE if your old part or paperwork says WB02X10943.
Model-bounded owner replacement sequence
For the JNM3163 family, the GE manual's charcoal-filter instructions apply to a non-outdoor-vented / recirculating setup. Disconnect power first. Open the microwave door, remove only the two grille screws at the top, slide the grille left and forward to remove it, then slide the charcoal filter down and out. Remove the new filter's packaging, seat its top in the inside grooves, and push the bottom into place. Align the grille tabs with the frame, slide the grille right, and reinstall its screws.
This is an owner-level filter procedure only. Do not open the microwave cabinet or perform any repair beyond the filter/grille steps in the owner's manual.
When to verify with GE before ordering
- The appliance label does not read the complete JNM3163RJSS model number.
- The old filter, receipt, or manual specifically says WB02X10943 and you need to know whether it maps to the current WB02X35607 listing.
- The installed venting configuration is unclear or the grille/filter shape does not match the manual.
- The exact-model GE page or current parts detail changes; recheck GE's model-specific fitment before buying.