Microwaves · parts
GE JVM3162RJSS microwave turntable parts: tray WB49X10129 and shaft WB06X10873
GE’s exact JVM3162RJSS Owner Center lists glass tray WB49X10129, described as 12.75 inches, and turntable shaft WB06X10873. GE Parts pages corroborate both item identities. The linked JVM3162RJSS manual requires the turntable and its support to be seated for microwave operation and warns that the tray/support can break if dropped. This record does not identify a motor or full turntable assembly or infer substitute trays from diameter.
Safety boundary
- Before using microwave mode, make sure the turntable and support are correctly seated as directed by the manual. Avoid dropping or handling a hot tray; stop if a replacement binds, rocks, or does not seat normally.
- Do not open the microwave chassis or replace internal drive components from this parts lookup; use qualified service for internal repairs.
Compatibility requires a direct model listing, explicit supersession, or equivalent manufacturer evidence.
Required identifiers
- Complete model label: JVM3162RJSS
- Old tray or shaft marking, if legible
- Whether the failed or missing piece is tray, shaft, roller support, or motor
- Confirm tray seats on the existing support without binding
Compatibility rules
- GE’s exact JVM3162RJSS Owner Center lists glass tray WB49X10129 and shaft WB06X10873.
- GE Parts identifies WB49X10129 as a 12.75-inch microwave glass tray and WB06X10873 as a microwave turntable shaft.
- Apply only to complete model JVM3162RJSS; GE’s source does not establish the other turntable components or a substitute based only on tray diameter.
Never assume
- A 12.75-inch tray alone proves fit if the hub shape or model differs.
- The shaft is the roller support or turntable motor.
- A spinning issue necessarily means one of the listed pieces failed.
- The appliance can be used in microwave mode without the manual-required tray/support assembly seated.
Exact model-to-part lookup
- Model: JVM3162RJSS.
- Glass tray: GE lists WB49X10129, a 12.75-inch microwave glass tray.
- Turntable shaft: GE lists WB06X10873 as a separate component.
- This list does not identify the motor or roller support.
Fit and use check
Compare the complete model label and existing part marking. After safe owner-level replacement, confirm the pieces seat normally; do not run the oven in microwave mode unless the tray and support are in place.