Industrial replacement referenceSource-backed records · No compatibility guesswork

Loading industrial replacement data

608SMT25 → 5608J25A replacement

Manufacturer-published selection

Browning 608SMT25 replacement

Falk / Rexnord 5608J25A appears in the same manufacturer-published cross-reference row as Browning 608SMT25 at 25:1 · AGMA size 608.

Published target5608J25AFalk / Rexnord25:1

Evidence publisherFalk / RexnordEvidence typePublished selectionReviewedSep 21, 2026Open source ↗

Replacement referenceDirectional lookup

Existing / searched modelBrowning608SMT25Open source-model record →

Published target modelFalk / Rexnord5608J25AOpen target specs →

What the source establishesPublished selection

Rexnord Table 1 publishes Falk 5608J25A with the listed competitor models for a 100 hp / 18 rpm selection at 1.0 service factor and 25:1 nominal ratio.

Evidence meaning

The manufacturer publishes the target as the selection for the stated competitor size, ratio, or duty point.

Browning 608SMT25 and Falk / Rexnord 5608J25A are tied by the published source at 25:1 · AGMA size 608.

Evidence boundary

Verify the installed unit against the source assumptions and current manufacturer ratings before purchase.

Browning 608SMT25 to Falk 5608J25A: selection and shaft checkFalk Quadrive Guide 371-810 · Tables 1 and 3

Published selection rowAt the page's 25:1 ratio, Table 1 lists Browning 608SMT25 and Falk 5608J25A on the 100 hp / 18 rpm row under its 1.0 service-factor selections.

Minimum recommended shaft engagementFor AGMA size 608, Table 3 lists 15.250 in for Browning and 12.75 in for Falk. Compare the available shaft length with the target drive's requirement before treating the selection as a fit.

Guide limitThe March 2006 guide says its information should be confirmed before ordering. Recheck current ratings and the installed unit's ratio, shaft and bushing, mounting, accessories, and duty with the manufacturer.

Published target specifications5 model-level fields

Falk / Rexnord5608J25AQuadrive

Full model record →

Maximum bushing / bore: 6 1/2 inSource ↗
Nominal ratio: 25 :1Source ↗
AGMA size: 608Source ↗
Published service factor: 1.0Source ↗
Published Table 1 duty example: 100 hp / 18 rpmSource ↗

Other models in the same published row5

Dodge Torque-Arm IITA12608H25Same 25:1 published row →Dodge TXTTXT1225Same 25:1 published row →Dorris700TRSame 25:1 published row →Falk 40004608J25CSame 25:1 published row →Link-Belt608D24Same 25:1 published row →

Replacement verification checklistBefore purchase

RatioConfirm nominal and actual ratio against required output speed.

Shaft / boreMeasure the driven shaft and verify bushing or bore configuration.

InputCheck high-speed shaft, motor frame, sheave and input interface.

MountingCompare center height, footprint, torque-arm geometry and housing clearances.

AccessoriesDo not assume existing backstops, motor mounts, belt guards or screw-conveyor hardware transfer.

DutyRecheck torque, service factor, shock, starts per hour, temperature and lubrication.

Open 5608J25A specifications Full published row Field checklist Source document ↗